Audio Bauer Pro - Onlineshop

0

Keine Artikel

  • Versand

    CHF 0.00
  • Gesamt

    CHF 0.00
Home > Sound Devices>Broadcast Essentials>Sound Devices MP-1

Sound Devices>Broadcast Essentials>Sound Devices MP-1

Home > Sound Devices>Broadcast Essentials>Sound Devices MP-1

Sound Devices>Broadcast Essentials>Sound Devices MP-1

Sound Devices MP-1

Einkanal Mikrofonvorverstärker

FRAGEN SIE UNS NACH DEM AKTUELLEN WÄHRUNGSRABATT / DEMANDEZ LE RABAIS DU COURS DU CHANGE

Artikel-Nr: 000612

CHF 639.00

Menge:

Sound Devices 1-Kanal Mikrofonvorverstärker

Portabler, 1-kanaliger Mikrofonvorverstärker mit Lundahl Ein- & Ausgangsübertragern und nahezu unklippbarem Limiter (max. Inputpegel +4 dBu) auf Optokopplerbasis. Robuste Vollmetallkonstruktion.

FEATURES:

1 Eingang, XLR, übertragersym., Mic-Pegel
12/48 V PH, Lo-Cut 80/160 Hz (6 dB/Okt.), Limiter
Gain 0-66 dB in 11 Stufen
20-22 KHz +/- 0.5 dB, EIN: -126 dBu, S/N 122 dB, THD+N 0,05 %
Output: XLR, übertragersym., max. Pegel 20 dBu / 600 Ohm

Equivalent Input Noise
  • -126 dBu (-128 dBV) maximum (150 ohm source, flat weighting, 22 - 22 kHz bandwidth, gain control set at 50% or higher, phantom power off)
Output Clipping Level (Line)
  • +22 dBu minimum with 100k ohm load, +20 dBu minimum with 600 ohm load
Dynamic Range
  • 110 dB minimum
THD + Noise
  • 0.05% maximum (from 60 Hz to 22 kHz @ +4 dBu output level, 22 Hz - 22 kHz filter bandwidth, gain control at 50%, phantom off)
Inputs
  • Transformer-balanced, 2k ohm input impedance
Outputs (XLR)
  • s/n < 0507 - impedance-balanced, 120 ohm output impedance, s/n >0507 - active-balanced, 120 ohm output impedance
Outputs (Tape)
  • Unbalanced, tip-left, ring-right, sleeve-ground, 2.4k ohm output impedance
Power (Internal)
  • 2 AA alkaline batteries, 6 hours life typical with +4 dBu signal into 600 ohms, no phantom power
Power LED
  • Green indicates power and good battery. Red indicates power and low battery. LED turns red when approximately 1 hour of battery life remain (with phantom power off). Green with external DC power.
Frequency Response
  • 20 Hz - 30 kHz, +0.1, -0.5 dB; -1 dB at 5 Hz & 50 kHz (relative to 1 kHz with 150 ohm source, gain controls set at 50%)
Input Clipping Level
  • -10 dBu minimum
Output Clipping Level (Tape)
  • +11 dBu (2.75 V RMS) minimum with 100k ohm load
Common Mode Rejection Ratio
  • 100 dB minimum at 80 Hz, 60 dB minimum at 10 kHz
Channel Separation
  • Greater than 80 dB at 1 kHz (gain controls set to 50%)
High-Pass Filters
  • 80 Hz or 160 Hz (switch selectable), 6 dB per octave
Phantom Power
  • 48 V through 6.8k resistors or 15 V through 680 ohm resistors (switch selectable)
Limiter
  • Thresholds adjustable per channel from -10 dBu to +17 dBu, 10:1 limiting ratio, 5 mS attack time, 100 mS release time, Amber/Red LED indicates limiting/clipping, Dual mono or stereo linked
Internal Voltage Rails
  • ±15 V, regulated
Polarity
  • All inputs to all outputs, non-inverting. Pin-2 of XLRs "hot" to unbalanced inputs and outputs.
Metering
  • Seven segment GaN (Gallium Nitride) LED meter with three intensities, peak responding
Operating Temperature Range
  • 0 to 70 degrees C, 32 to 160 degrees F
Dimensions
  • 43 mm x 94 mm x 140 mm (h x w x d), (1.7" x 3.7" x 5.5")
Weight (unit only)
  • 0.8 kg, 2.0 lbs.
Weight (packaged)
  • 1.2 kg, 3.0 lbs.
Certifications
  • Meets FCC Part 15 Class B, eligible to bear CE mark

4 andere Artikel der gleichen Kategorie:

Sound Devices MD-4
CHF 1'809.00
Sound Devices USBPre 2
CHF 1'149.00
Sound Devices HX-3
CHF 639.00
Sound Devices MM-1
CHF 789.00